Figure 55 Vlan Configuration Screen; Table 21 Vlan Configuration Screen Fields - Nortel 1000ASE-XD Using Manual

Figure 55 VLAN Configuration screen

Table 21

Table 21 VLAN Configuration screen fields

Field
Create VLAN
Delete VLAN
describes the VLAN Configuration screen fields.
Description
Allows you to set up or view configured VLAN workgroups. Enter the number of the
new VLAN you want to create or view, then press [Return]. The Port Membership
fields indicate the corresponding VLAN workgroup configuration, if configured.
Dashes (-) indicate no VLAN Members are configured. Alternatively, you can use
the space bar to toggle through the various configured VLAN workgroups. You can
create up to 32 different VLANs (except VLAN #1).
Default 1
Range 2 to 4094
Allows you to delete specified VLANs, except the assigned management VLAN
(See Management VLAN field). Enter the number of the VLAN you want to delete,
then press [Return], or use the space bar to toggle through the selection until you
reach the VLAN you want to delete, then press [Return].
The specified VLAN is deleted as soon as you press [Return]. The software does
not prompt you to reconsider this action. If you delete a VLAN, all configuration
parameters that are associated with that VLAN are deleted also.
You cannot delete VLAN 1. By default, all switch ports are assigned as untagged
members of VLAN 1 with all ports configured as PVID = 1. See
workgroups" on page 54
Chapter 3 Using the console interface
for more information.
Using the BayStack 420 10/100/1000 Switch
123
"IEEE 802.1Q VLAN