Account/Call Settings - Grandstream Networks WP810 Administration Manual

Jitter Buffer Type
Jitter Buffer Length
Voice Frames Per TX
G.726-32 Packing
Mode
iLBC Frame Size
iLBC Payload Type
OPUS Payload Type
DTMF Payload Type
Send DTMF

Account/Call Settings

Call Log
Send Anonymous
Anonymous Call
Rejection
Selects either Fixed or Adaptive for jitter buffer type, based on network
conditions. The default setting is "Adaptive".
Selects jitter buffer length from 100ms to 800ms, based on network
conditions. The default setting is "300ms".
Configures the number of voice frames transmitted per packet. When
configuring this, it should be noted that the "ptime" value for the SDP will
change with different configurations here. This value is related to the codec
used and the actual frames transmitted during the in-payload call. For end
users, it is recommended to use the default setting, as incorrect settings may
influence the audio quality.
The default setting is 2.
Selects "ITU" or "IETF" for G726-32 packing mode. The default setting is
"ITU".
This option determines the iLBC packet frame size. Users can choose from
20ms and 30ms. The default setting is "30ms".
This option is used to specify iLBC payload type. Valid range is 96 to 127.
The default setting is "97".
Specifies OPUS payload type. Valid range is 96 to 127. Cannot be the same
as iLBC or DTMF Payload Type. Default value is 123.
Configures the payload type for DTMF using RFC2833. Cannot be the same
as iLBC or OPUS payload type.
This parameter specifies the mechanism to transmit DTMF digits. There are
3 supported modes:
• In audio: DTMF is combined in the audio signal (not very reliable with low-
bit-rate codecs).
• RFC2833 sends DTMF with RTP packet. Users can check the RTP packet
to see the DTMFs sent as well as the number pressed.
• SIP INFO uses SIP INFO to carry DTMF.
Default setting is "RFC2833".
Configures Call Log setting on the phone. You can log all calls, only log
incoming/outgoing calls (missed calls will not be logged) or disable call log.
The default setting is "Log All Calls".
If set to "Yes", the "From" header in outgoing INVITE messages will be set to
anonymous, blocking the Caller ID to be displayed. Default is "No".
If set to "Yes", anonymous calls will be rejected.
The default setting is "No".
WP810 Administration Guide
Version 1.0.1.1
P a g e | 43