Tv Signal Amplifier - Winnebago Journey 34Y Owner's Manual

SECTION 8 –
ENTERTAINMENT
The digital antenna is equipped with a built-in
amplifier for maximum VHF and UHF
programming.
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
Operating the Digital Antenna
1. Turn the Digital Antenna Power Switch ON.
Digital Antenna Power Switch
(Located in an overhead cabinet or
mounted on a wall near the TV)
2. Turn ON the Signal Meter Power switch
(located on the side of the Signal Meter).
• Signal Meter
Power Switch
• Attenuator
Dial
• Release
Button
Digital Antenna Signal Meter
(Located on ceiling)
3. Rotate the Attenuator Dial fully
CLOCKWISE.
4. Press Release Button on the Rotational Knob
and rotate antenna (until maximum number of
LED lights illuminate on the Signal Meter).
8-10
• Rotational Knob
(arrow indicates
which direction
antenna is pointing)
NOTE: LED lights will illuminate from left to
right. All LED lights may not illuminate,
depending on signal strength.
5. Rotate Attenuator Dial COUNTER-
CLOCKWISE until the last illuminated LED
light flickers.
6. Rotate antenna to illuminate the last flickering
LED light.
7. Repeat Steps 5 and 6 to pinpoint signal
reception.
NOTE: Refer to television manufacturer's
instructions to scan for available
channels.
Further Information
See the antenna manufacturer's user guide
provided in your InfoCase for complete operating
and maintenance information.

TV SIGNAL AMPLIFIER

The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch located on a switchplate below or inside
the front overhead entertainment center cabinet.
An indicator light will glow when the switch
is on and the signal amplifier is active.
Push On-Off
TV Signal Amplifier Power Switch
-Typical View