Utility Light; Water Pump - Winnebago Journey 34Y Owner's Manual

Hide thumbs Also See for Journey 34Y:
Table of Contents

Advertisement

SECTION 7 –
PLUMBING
5. Turn OFF city water supply and disconnect
from City Water Connection.
6. Turn Fresh Water valve to Normal position to
use the water pump. The Tank Fill position is
only for pressure filling the water tank from
the city water hose connection.
Fresh Water Valve in Normal use position
(Located in water service center)
Using City Water
When connected to an outside source of water,
the water bypasses the water pump and storage
tank and supplies pressure directly to individual
faucets and toilet. A check valve built into the
pump prevents water from entering the pump and
filling the storage tank.
1. Connect hose to City Water Connection as
described in previous steps.
2. Turn Fresh Water valve to Normal position
and turn the water pump switch(es) OFF.
Fresh Water Valve in Normal use position
(Located in water service center)
NOTE: Always keep the tank fill valve in Normal
position unless you are filling the tank. If
this valve is left in the Tank Fill position
while using the city water, water will
keep flowing into the tank and out the
7-2
tank vent tube onto the ground and the
water pump will run without delivering
water to faucets.
Disconnecting from City Water
1. Turn the city water source OFF.
2. Open a faucet on the coach (such as the
exterior wash station, if equipped) to relieve
line pressure.
3. Disconnect the city water hose from the coach
and replace the cap on the Fresh Water Inlet.
NOTE: Ensure the Fresh Water valve is in
NORMAL position to use the water
pump. If the valve is in Tank Fill position,
the pump will run continuously without
delivering water.

UTILITY LIGHT

A light is located on the sidewall to illuminate
the utility hook-up area when needed.
The switch is located in the water service
center compartment.
- Typical View

WATER PUMP

When your coach is not connected to a city
water supply, water is supplied from the fresh
water tank by a water system demand pump. A
demand pump is designed to run only when you
are using water. When you open a faucet, the
waterline pressure drops and the pump begins to
run, and it will continue to run as long as the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Journey 40uJourney 42eJourney 36m

Table of Contents