Winnebago Journey 34Y Owner's Manual page 113

Accessory Connection Cables
* Satellite Receiver 1 and Satellite Receiver 2
(Located in front driver overhead cabinet)
NOTE: Auxiliary AV Component Cable not provided.
• Power "ON" TV, HDMI Video Selection
System, and Satellite Receiver.
• Determine which TV you want to use (e.g.
BEDROOM for bedroom TV) and select
"Satellite Receiver 1" from the HDMI Video
Selection System (or the HDMI Video
Selector Control or the Secondary Source
Selector).
• On the TV remote, press the
SOURCE or FUNCTION/
TV SOURCE button and
select "HDMI 1".
The TV will display the satellite logo when the
correct input is selected.
Infrared Emitters
The HDMI Video Selection System in your
coach is also featured with Infrared Emitters
(connected to both Accessory Connection
Cables), which are used to extend the remote
control from all TV's in the coach to either
Satellite 1, Satellite 2, or Auxiliary. Install in
front of receiver for proper operation.
To Watch Broadcast TV (Antenna)
• Power "ON" the TV Signal Amplifier Power
switch (located in overhead cabinet above
entry door.) A green LED light will illuminate
when the switch is on and the signal amplifier
is active.
All TV's in the coach will now be connected
to the roof antenna (via coax cable) and set TV
to be viewed through antenna input.
• Press the SOURCE or FUNCTION/TV
SOURCE button on the TV remote and select
"TV" (Antenna).
TV Signal Amplifier Power Switch
(Located in overhead cabinet
above entry door)
NOTE: You must perform a channel search and
program TV for available channels if you
have moved your coach to a new
destination.
Refer to the TV manufacturer's user
guide provided in your InfoCase for
complete operating instructions.
SECTION 8 –
ENTERTAINMENT
8-3