Winnebago Journey 34Y Owner's Manual page 108

SECTION 7 –
PLUMBING
Ice Maker Winterization Drain Valve
(Located behind sidewall access door)
* Disconnect water supply line from Ice
Maker Winterization Drain valve before
winterizing with RV antifreeze
2. Turn Ice Maker Winterization Drain valve
(located behind sidewall access door) to the
ON position.
NOTE: Leave the Ice Maker Winterization Drain
valve in the ON position throughout
storage period.
Ice Maker Winterization Drain Valve
(Located behind sidewall access door)
-Typical View
3. After the last batch of ice dispenses, raise the
wire shut-off arm to the OFF position.
4. Empty ice bin.
To use Ice Maker again after seasonal storage:
1. Flush antifreeze from the waterlines (if
antifreeze fill winterization procedure was
performed).
2. Close all drain valves.
3. Turn Ice Maker Winterization Drain valve to
the OFF position.
4. Turn the water supply ON.
7-20
5. Ensure the ice bin is in place and the wire shut-
off arm is lowered to the ON position.
6. Allow the refrigerator to cool down to ice
making temperature. Remember, this can take
up to 24 hours.
NOTE: Discard the first two batches of ice
cubes. It will take approximately three
cycles for the Ice Maker to produce fully
formed, clean ice cubes.
Winterizing Washer/Dryer
(Stackable)
–If Equipped
Method 1 – Drain Water
If you have decided to completely drain the
coach waterlines, follow these steps to winterize
your Washer/Dryer:
1. With the Washer/Dryer power OFF, pour 1/2
quart of RV-type antifreeze into the Washer
drum.
2. Close door. Advance Cycle Selector to "B".
3. Press ON/OFF button, then press START. Let
the Washer/Dryer run for 1 to 2 minutes.
4. Press ON/OFF button to turn power OFF.
5. Unplug Washer/Dryer from electrical outlet
(or disconnect power).
6. Turn Water Supply Faucets OFF. Disconnect
inlet hoses from faucets.
7. Drain remaining water from hoses. Finished.
To use Washer/Dryer again after seasonal
storage:
1. Reconnect water inlet hoses to corresponding
HOT/COLD faucets. Turn faucets ON.
NOTE: Check water inlet hoses and pump
periodically (see manufacturer's user
guide for further information).
2. Plug Washer/Dryer into electrical outlet (or
reconnect power).
3. With Washer/Dryer power OFF, pour 1/2
TBSP. of powder detergent (or liquid
equivalent) into "Compartment 2" inside
Dispenser Drawer.
4. Advance Cycle Selector to "Position 4".
5. Press ON/OFF button, then press START.