Winnebago Journey 34Y Owner's Manual page 145

Rear slideout switches (if equipped) are
located on a wall near the slideout room or the
Systems Monitor Panel. Location varies by
model and floorplan.
Slideout Switches
(Your coach may have one or more of these
switches depending on model, options, and
available equipment)
-Typical View
CAUTION
Never drive the vehicle with a slideout
room extended!
The slideout room system uses 12-volt DC
motorized mechanisms with an electronic control
system to provide smooth operation and positive
weather seal.
NOTE: We recommend that you KEEP THE
ENGINE RUNNING WHILE
EXTENDING OR RETRACTING
SLIDEOUT ROOMS so the engine
alternator can provide maximum power
for proper operation of the slideout
mechanisms.
WARNING
CRUSH HAZARD. Keep people and
objects clear of the inside and outside of
the slideout room when operating. Failure
to comply could result in death or serious
injury.
SLIDEOUT ROOMS AND LEVELING
To Extend Slideout Room
Before Extending!
• Level the coach and set the Parking Brake.
• Release the travel lock or latch (if equipped)
inside the coach. See information at beginning
of this section (if equipped).
• Ensure exterior compartment doors are closed
so that they will not interfere with slideout
operation.
• Check inside and outside the vehicle to make
sure that there are no people who could be
harmed or obstacles that could cause damage
due to room extension.
• If the slideout room has a couch or other
furniture, make sure no people or pets are
seated on them until the room has been fully
extended.
NOTICE
Release slideout room travel latch before
attempting to extend slideout room.
Secure travel latch before driving vehicle.
Extend Procedure:
See "Before Extending!" before proceeding.
• Start the engine so the alternator can provide
maximum power for proper operation of
slideout mechanisms.
• Insert the Safety Lock key and turn to activate
slideout room control switch.
• Press the Slideout Room "EXTEND/OUT"
switch and hold until the room is fully
extended, then release the switch.
• To stop extending the room during operation,
release the button.
• Deactivate the slideout switch with the Safety
Lock key.
SECTION 10 –
10-3