Table of Contents
Advertisement
Copy
to model:
01
Graubele
1234g/080811
Test
02
Ultimate
03
Starlet
trim needed
04
BELL47G
05
free
After confi rming the selected model memory with
a tap on the
SET
key, a confi rmation request will
appear:
Model really
02
Ultimate
05
to be copied?
NO
A
NO
response will cancel the process and return
the screen to the originating screen. If the YES
response is selected and confi rmed with a tap on
the
SET
key then the selected source model will be
copied into the selected model memory destination.
Note:
In addition to model data, binding data is also copied
by this process. This means that a receiver system
which was/is bound to the original model memory can
also be operated by its copy without establishing the
bond again.
Exporting to SD card
Use the selection keys of the left or right touch
01:23hR16
pad to select the »Export to SD« sub-menu then tap
00:44hR12
on the
SET
key.
00:33hR08
Erase model
00:22hR08
Copy modeModell –> Modell
Expor t to SDach SD-Kar te
Impor t from von SD-Kar te
Copy flight sen kopieren
If the message shown above should appear, the
transmitter's RF module is still active. Switch the
free
RF module off as described on page 80 then also, if a
receiver system is currently switched on, switch off that
receiver too. This is to be done for reasons of safety.
Choose the model to be exported with the
YES
selection keys of the left or right touch pad ...
expor t to SD-Card:
01
Graubele
02
Ultimate
03
Starlet
04
BELL47G
05
After confi rming the selected model memory with a tap
on the
SET
key, a confi rmation request will appear:
Model really
02
expor t?
Please select
RF on/off?
=>
ON
OFF
1234g/080811
01:23hR16
Test
00:44hR12
trim needed
00:33hR08
00:22hR08
free
Ultimate
NO
YES
A
NO
response will cancel the process and return
the screen to the originating screen. If the YES
response is selected then confi rmed with a tap on the
SET
key, the selected model will be copied to the SD
card.
Notes:
•
Should the notice ...
SD-CARD
INSERT
OK
... appears instead of a screen for model
selection, there is no SD card in the transmitter's
card slot, see page 23.
•
In addition to model data, binding data is also
copied by this process. This means that a receiver
system which was/is bound to the original model
memory can also be operated in the SAME
transmitter by its copy without establishing the
bond again.
•
An exported fi xed-wing model will be stored on
the memory card in the \\Models\mc-32 folder
with a fi lename format of "aModelname.mdl"
and a helicopter model with a fi lename format
of "hModelname.mdl". On the other hand, if a
"nameless" model is exported, its data will be
stored on the memory card under "ahNoName.
mdl" or "hNoName.mdl", as appropriate.
•
Some special characters that can be used in
model names are subject to specifi c restrictions
associated with the FAT or FAT32 fi le system used
by the memory cards and these special characters
will be replaced during the copy process with a
tilde (~).
•
A model fi le already on the memory having
the same name as the fi le to be copied will be
overwritten without warning.
Detail program description - Copy / Erase
71
Advertisement
Table of Contents
