Table of Contents
Advertisement
Detail program description
Loading a new memory location
Anyone who has worked through to this part of
the manual has certainly already tried out a bit of
programming. Nevertheless a detailed description of
every menu should not be left out.
This section begins with the loading of a "free"
memory location, a procedure which would be
performed if a new model was being "programmed".
Stop watch
#01
0:00h
Flight tim
00:00h
K78
4.1V
V
M
0
0
0
From the basic display, a jump to the "Multi-function
list" is made with a tap on the center
right touch pad. (The center
ESC
key of the left touch
pad will cause a jump back to the basic display.)
By default, when the multi-function list is called for
the fi rst time after switching on the transmitter, the
»Model select« menu option will be active and
displayed in inverse video. Otherwise use the
or selection keys of the left or right touch pad to
select the »Model select« menu option , whereby the
upper of the two following fi gures shows a selection
list for a fi xed-wing model and the lower shows the
selection list for a helicopter model.
Model select
Copy / Erase
Suppress codes
Suppress models
Base setup model
Model type
Ser vo adjustment
Stick mode
Control adjust
Dual Rate / Expo
Channel 1 cur ve
Switch display
66
Detail program description - Loading a new memory location
Model select
Suppress codes
Base setup model
Ser vo adjustment
Control adjust
Channel 1 cur ve
0:00.0
Tap briefl y on the center
0:00.0
pad to open this menu option:
01
02
RX VOLT:0.0v
03
0
04
05
SET
key of the
06
In the transmitter's delivered state, the fi rst model
memory is initialized to the "fi xed-wing model" type
and the receiver in the delivery is "bound" to this
model. The time display located near the line's middle
indicates the overall operating time of the respective
model memory.
The remaining memory locations, marked with
"
free
also "non-bound". If you wish to program a fi xed-wing
model then, after leaving the »Model select« menu
with a tap on the center
programming of the model can begin right away ... or
now use the or keys of the left or right touch pad
to select one of the free memory locations ...
Copy / Erase
Suppress models
Helicopter type
Stick mode
Dual Rate / Expo
Switch display
SET
key of the right touch
00:12h
E16
free
free
free
free
free
", are still unoccupied and therefore
ESC
key of the left touch pad,
01
02
free
03
free
04
free
05
free
06
free
... and then tap on the center
SET
touch pad to confi rm the choice.
Afterward you will be prompted to select the basic
model type, i.e. either "winged model" or "helicopter
model".
Select model type ( free model memor y )
Use the or keys of the left or right touch pad to
select the basic model type then tap on the center
SET
key of the right touch pad. This initializes the
selected model memory with the selected model type
and the display will return to the base screen. The
memory location is now accordingly occupied.
However, if you wish to begin with a helicopter,
select one of the memory locations marked
" with the or keys of the left or
"
free
right touch pad then confi rm the selection with a brief
tap on the center
SET
key of the right touch pad. You
will be now be prompted to specify the basic model
type, in this case the "helicopter model". Select the
appropriate symbol with the or keys of the left
or right touch pad then again tap briefl y on the center
SET
key of the right touch pad to confi rm the choice.
This initializes the selected model memory with the
00:12h
R16
key of the right
Advertisement
Table of Contents
