Table of Contents
Advertisement
DES-3550:4#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X
Authentication Mode
Authentication Protocol : Radius_Eap
Port number
Capability
AdminCrlDir
OpenCrlDir
Port Control : Auto
QuietPeriod
TxPeriod
SuppTimeout
ServerTimeout : 30
MaxReq
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C ESC q
show 802.1x auth_state
Purpose
Used to display the current authentication state of the 802.1x server
on the switch.
Syntax
show 802.1x auth_state {ports <portlist>}
Description
The show 802.1x auth_state command is used to display the current
authentication state of the 802.1x Port-based Network Access Control
server application on the switch.
ports<portlist> − Specifies a port or range of ports to be viewed.
Parameters
The following details what is displayed:
Port number − Shows the physical port number on the switch.
Auth PAE State: Initalize|Disconnected|Connecting|
Authenticating|Authenticated|Held |ForceAuth|ForceUnauth − Shows
the current state of the Authenticator PAE.
Backend State: Request|Response|Fail| Idle|Initalize|Success
|Timeout − Shows the current state of the Backend Authenticator.
Port Status: Authorized|Unauthorized − Shows the result of the
authentication process. Authorized means that the user was
authenticated, and can access the network. Unauthorized means that
the user was not authenticated, and cannot access the network.
: Enabled
: Port_based
: 1
: None
: Both
: Both
: 60
sec
: 30
sec
: 30
sec
sec
: 2
times
Quit
SPACE n
Next Page
123
Enter
Next Entry
a
All
Advertisement
Table of Contents
