Mac Notification Commands - D-Link DS-3550 Command Line Interface Reference Manual

The MAC Notification Commands in the Command Line Interface (CLI) are listed, in the following table, along with their
appropriate parameters.
Command
enable mac_notification
disable mac_notification
config mac_notification
config mac_notification
ports
show mac_notification
show mac_notification
ports
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To enable MAC notification without changing basic configuration:
disable mac_notification
Purpose
Syntax
Description
Parameters
{interval <int 1-2147483647> | historysize <int 1-500>
[<portlist> | all] [enable | disable]
ports <portlist>
<portlist>
Used to enable global MAC address table notification on the switch.
enable mac_notification
This command is used to enable MAC address notification without
changing configuration.
None.
Only administrator-level users can issue this command.
DES-3550:4#enable mac_notification
Command: enable mac_notification
Success.
DES-3550:4#
Used to disable global MAC address table notification on the switch.
disableable mac_notification
This command is used to disable MAC Address Notification without
changing configuration.
MAC N
OTIFICATION
158
26
C
OMMANDS