Table of Contents
Advertisement
config authen_enable
Restrictions
Example usage:
To configure the user defined method list "Permit" with authentication methods tacacs, xtacacs and local, in that order.
tacacs – Adding this parameter will require the user to be
authenticated using the tacacs protocol from the remote
tacacs server hosts of the tacacs server group list.
xtacacs – Adding this parameter will require the user to be
authenticated using the xtacacs protocol from the remote
xtacacs server hosts of the xtacacs server group list.
tacacs+ – Adding this parameter will require the user to be
authenticated using the tacacs protocol from the remote
tacacs+ server hosts of the tacacs+ server group list.
server_group <string 15> - Adding this parameter will
require the user to be authenticated using a user-defined
server group previously configured on the switch.
local_enable - Adding this parameter will require the user to
be authenticated using the local user account database on
the switch.
none – Adding this parameter will require no authentication
to access the switch.
method_list_name – Enter a previously implemented method list
name defined by the user (create authen_enable). The user may add
one, or a combination of up to four (4) of the following authentication
methods to this method list:
tacacs – Adding this parameter will require the user to be
authenticated using the tacacs protocol from a remote
tacacs server.
xtacacs – Adding this parameter will require the user to be
authenticated using the xtacacs protocol from a remote
xtacacs server.
tacacs+ – Adding this parameter will require the user to be
authenticated using the tacacs protocol from a remote
tacacs server.
server_group <string 15> - Adding this parameter will
require the user to be authenticated using a user-defined
server group previously configured on the switch.
local_enable - Adding this parameter will require the user to
be authenticated using the local user account database on
the switch. The local enable password of the device can be
configured using the "config admin local_password"
command.
none – Adding this parameter will require no authentication
to access the administration level privileges on the switch.
Only administrator-level users can issue this command.
171
Advertisement
Table of Contents
