Enabling Auto Configuration - Nomadix AG-2000W User Manual

Enabling Auto Configuration

As shown in the diagram below, two subsequent events drive the automatic
configuration of Nomadix devices:
A flow of RADIUS Authentication Request and Reply messages between
1.
the Nomadix gateway and the centralized RADIUS server that specifies the
location of the meta configuration file (containing a listing of the individual
configuration files and their download frequency status) are downloaded
from an FTP server into the flash of the Nomadix device.
Defines the automated login into the centralized FTP server and the actual
2.
download process into the flash.
The Auto-Configuration setup requires a few basic steps to be completed by both the
field engineer and the NOC administrator.
Administrative Steps to Enable Auto-Config
Typically, these tasks are performed either at a device pre-staging center or by the
field engineer.
Establish a WAN connection and electronically accept the EULA.
1.
Setup RADIUS Server parameters (go to
2.
Settings {RADIUS Client}" on page
Setup Username and Password for RADIUS Authentication.
3.
74
N AG-2000
OMADIX
Step 1: RADIUS Authen Req/
Response message to
determine location of meta
configuration file
Step 2: FTP download of
configuration files (secure)
"Defining the RADIUS Client
92).
™ / AG-2000 ™
W WA
System Administration