Nomadix AG-2000W User Manual page 93

N AG-2000 ™ / AG-2000
OMADIX W
You must reboot the system if you make changes to any of the following
IP settings.
You may lose your connection if you change the IP settings incorrectly
(using invalid IP addresses). If you "misconfigure" the AG-2000w and
network connectivity is lost, you can still access the AG-2000w from the
Admin IP address (172.30.30.172).
Enable or disable the
3.
you can skip Step 4 through Step 6.
Enter a valid IP address in the
4.
The Network IP Address is the public IP address that allows administrators to see
the AG-2000w on the network. Use this address when you need to make a
network connection with the AG-2000w.
All IP addresses must be established, otherwise the AG-2000w will not
be "visible" on the network.
Enter a valid IP address in the
5.
The subnet mask defines the number of IP addresses that are available on the
routed subnet where the AG-2000w is located.
Enter a valid default gateway IP address in the
6.
The default gateway is the IP address of the router that the AG-2000w uses to
transmit data to the Internet.
When finished, you must reboot the system for the new settings to take effect.
7.
Click on the check box for
system after saving your changes.
Click on the
8. Submit
on the button if you want to reset all the values to their previous state.
Reset
System Administration
™
WA
, as required. If you are using a DHCP Client,
DHCP Client
Network IP Address
Subnet Mask
Reboot after changes are saved?
button to save your changes and reboot the system, or click
field.
field.
field.
Default Gateway
to reboot the
89