Canon iR2025 Reference Manual page 201

3
4
4
4-46
Specifying Common Settings
Select [Speed] or [Print Side] for each paper source ➞ press [OK].
Details of each item are shown below.
[Speed]: When you feed one- or two-sided prints into the machine, the method for
delivering paper inside the machine changes, and this affects the printing
speed. Therefore, to maximize the printing speed, load the paper manually as
follows:
One-Sided Prints:
Two-Sided Prints:
[Print Side]: If you load paper in a paper drawer and select [Print Side], no matter whether
you are printing one- or two-sided prints, the side of the paper facing down is
always the one printed on first. (The side facing up is the one printed on first
for the stack bypass.) However, some speed will be sacrificed when printing
one-sided prints.
If [Print Side] is selected for a paper source, and Drawer Eligibility For APS/ADS in Common
Settings (from the Additional Functions screen) is set to 'On', the Automatic Paper Selection
and Automatic Drawer Switching settings are ignored. Also, the machine's printing speed may
become slower when you print one-sided documents.
The selected mode is set.
Press [Done] repeatedly until the Basic Features screen appears.
Load the paper face up in a paper drawer, or face down into the
stack bypass. The side facing up in the paper drawer, and the side
facing down in the stack bypass are the sides printed on.
Load the paper face down in a paper drawer, or face up in the stack
bypass. The side facing down in the paper drawer, and the side
facing up in the stack bypass are the first sides that are printed on.