Using The Guest Mode; Maintenance Of The Device - Hartmann Tensoval Instructions For Use Manual

measured value in memory, this
stored value cannot be deleted. It is
not possible to delete individual
values.

5.4 Using the guest mode

When a third person uses Tensoval
mobil, it is recommended that they
use the guest mode. This one is
used to store a measured value nei-
ther to the memory positions M1
nor to M2. This avoids bias to the
average values and stored values of
the two main users of the device.
To take measurements in guest
mode, start the measuring proce-
dure by simultaneously pressing
memory buttons M1 and M2. The
START/STOP button needs not be
pressed.
At the end of measurement the dis-
play simultaneously shows both M1
and M2 above the measured values
rather than either symbol alone.
The measured value can thus not
be applied to either person, and
the measured values will not be
stored.
To switch off the device, press the
START/STOP button, also in guest
mode. Otherwise the device will
switch itself off automatically after
3 minutes.

6. Maintenance of the device

Do not expose the device neither to
extreme temperatures nor to
humidity, dust or direct sunlight
because this may lead to malfunc-
tion. This device consists of high-
quality electronic precision compo-
nents. Protect the device from
shock and do not immerse in water.
Only use a soft, moistened cloth to
clean the device. Please use neither
a diluter nor alcohol, detergents or
solvents. The cuff can be cleaned
carefully with a lightly moistened
cloth and mild, pH neutral soap. Do
not completely immerse the cuff in
water and do not remove it from
the device.
92