Can-Am Outlander X mr Series Operator's Manual page 143

NOTE: Ensure filler cap diaphragm is
pushed inside the cap before closing
the brake fluid reservoir.
Recommended Brake Fluid
Always use brake fluid meeting the
specification DOT 4 only.
NOTICE
To avoid serious damage
to the braking system, do not use
fluids other than the recommended
one, nor mix different fluids for top-
ping up.
Brake Inspection
CAUTION The brakes can be
very hot after prolonged use of the
vehicle and can cause burns. Wait
for the brakes to cool down.
Check the following to keep the brakes
in a good operating condition:
– Brake fluid level
– Brake system for fluid leaks
– Brake for spongy feel
– Brake cleanliness
– Brake discs for excessive wear and
surface condition
– Brake pads for wear, damage or
looseness.
SERVICE LIMITS
Brake pads
thickness
Front discs
thickness
Rear disc
thickness
Maximum discs
warpage
See your authorized Can-Am dealer if
a problem is detected concerning the
brake system.
1.0 mm (.039 in)
4 mm (.157 in)
4 mm (.157 in)
0.2 mm (.008 in)
______________
MAINTENANCE PROCEDURES
WARNING
The brake fluid replacement or
brake system maintenance and
repairs should be performed by an
authorized Can-Am dealer.
141