Fuses - Can-Am Outlander X mr Series Operator's Manual

MAINTENANCE PROCEDURES
Disconnect BLACK (-) cable first then
RED (+) cable.
Remove the retaining screws and the
battery holder, then pull the battery out
of frame.
vmo2012-012-031_a
1. Battery holder
2. Retaining screws
Battery Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush.
Battery Installation
Reinstall battery in vehicle.
NOTICE
Always connect RED (+)
battery cable first.

Fuses

CAUTION Always turn the ig-
nition switch to OFF position before
replacing a defective fuse.
Fuse Inspection
Check if filament is melted.
If filament is melted, replace damaged
FUSE LOCATION
fuse, refer to
for proper rating.
______________
132
A15E0KY
TYPICAL
1. Fuse
2. Check if melted
NOTICE
fuse as this can cause severe dam-
age.
Front Fuse Location
To gain access to the fuse box, located
between the radiator and the front con-
sole, remove the radiator cover and
then the gauge support as follows:
1. Release the latch on each side of the
radiator cover, push on the two tabs
and remove the cover.
vmo2013-009-018_a
Step 1: Release the latches
Step 2: Push on the tabs
1. Radiator cover
tables
2. Carefully release and remove the
gauge support from its location.
Do not use a higher rated
1
2