Can-Am DS 450 Series Operator's Manual page 79

Install FOX air pump to the EVOL air
chamber valve as follows.
1. Remove cap from EVOL air cham-
ber valve.
vmo2013-012-002_b
1. EVOL air chamber cap
2. Thread the pump chuck valve until
pressure registers on pump.
NOTE: Approximately 6 turns are re-
quired.
NOTICE
Do not overtighten.
NOTE: Air from EVOL air chamber
will fill the pump hose. Therefore, the
pressure reading may be as much as
69 kPa to 138 kPa (10 PSI to 20 PSI)
lower than previously set.
3. Set EVOL air chamber pressure us-
ing the HIGH pressure gauge.
NOTICE
Do not exceed 2 070 kPa
(300 PSI). Internal shock absorber
damage could occur.
4. Reinstall cap on EVOL air chamber
valve.
Main Air Chamber Pressure
The pressure in the MAIN air chamber
is adjusted to change ride height and
roll/pitch stiffness of the ATV.
Set the EVOL air chamber pressure
before setting the MAIN air cham-
ber pressure. This allows proper
location of the floating piston in
the EVOL air chamber. Otherwise,
poor shock performance and a po-
tentially unsafe vehicle behavior
may occur.
Install FOX air pump to the MAIN air
chamber valve as follows.
1. Remove cap from MAIN air cham-
ber valve.
vmo2013-012-002_a
1. MAIN air chamber cap
2. Set MAIN air chamber pressure us-
ing the LOW pressure gauge.
NOTICE
(100 PSI). Internal shock absorber
damage could occur.
3. Reinstall cap on MAIN air chamber
valve.
_______________
TUNE YOUR RIDE
WARNING
Do not exceed 690 kPa
77