Can-Am DS 450 Series Operator's Manual page 110

MAINTENANCE PROCEDURES
mmr2009-005-001_a
vmo2008-018-040_a
2. Adjust headlight housing angle by
hand.
3. Adjust both headlights evenly.
4. Tighten screw when proper adjust-
ment is reached.
Headlights Bulbs Replacement
NOTICE
Never touch glass portion
of a halogen bulb with bare fingers,
it shortens its operating life. If glass
is touched, clean it with isopropyl al-
cohol which will not leave a film on
the bulb.
NOTE: Concerning the following il-
lustrations, the headlight housing has
been removed from the vehicle for a
better comprehension.
To replace the headlight bulb, proceed
as follows.
Turn the ignition switch to OFF posi-
tion.
Remove rubber protector from head-
light housing.
______________
108
vmo2008-018-038_a
TYPICAL
1. Rubber protector
Unplug connector from headlight.
Push the retaining clip round ends for-
ward then set them on the sides to un-
lock headlight bulb.
vmo2008-018-036_a
TYPICAL
1. Retaining clip
Lift and hold the retaining clip then re-
move the bulb.
vmo2008-018-037
TYPICAL