Can-Am DS 450 Series Operator's Manual page 104

MAINTENANCE PROCEDURES
vmo2010-012-001_a
LH SIDE OF ENGINE
1. Access plugs
2. Clutch cover
Verify through clutch cover upper win-
dow if clutch cable and clutch release
cam are fully released.
vmo2010-012-002_a
1. Clutch cable
2. Clutch release cam
A. 4 mm to 5 mm (.16 in to .2 in)
Install CLUTCH
WRENCH 11 MM (P/N 529 036 076)
provided in tool kit onto lock nut.
529036076
CLUTCH ADJUSTMENT WRENCH
______________
102
ADJUSTMENT
vmo2008-011-071_a
1. Lock nut
Hold adjustment screw using a flat
screwdriver, then loosen lock nut
counterclockwise.
vmo2008-011-085_a
1. Screwdriver
2. Clutch adjustment wrench
By using the screwdriver, gently turn
clutch adjuster screw clockwise to lo-
cate the point of contact with release
bearing, then turn screw out (counter-
clockwise) 3/8 to 1/2 turn from contact
point.
Hold adjustment screw using the flat
screwdriver, then tighten lock nut
clockwise using the clutch adjustment
wrench.