Drive Chain - Can-Am DS 450 X mx Operator's Manual

MAINTENANCE PROCEDURES
1. Tabs
For installation, reverse the removal
procedure.

Drive Chain

WARNING
Always turn ignition switch to the
OFF position before you check, ad-
just or lubricate the drive chain.
Drive Chain Inspection
This vehicle is equipped with O-ring
sealed permanently greased pins and
rollers. Before operating the vehicle,
always inspect the drive chain.
Check for damage or missing O-ring,
rollers and correct slack adjustment.
Drive Chain Lubrication and
Cleaning
NOTICE
Never wash the chain
with a high pressure washer or gaso-
line. This will result in damage to the
O-ring, causing premature wear and
drive chain failure.
Clean the side surfaces of the chain
with a dry cloth.
NOTE: Do not brush chain.
______________
108
Lubricate only with an approved O-ring
chain lubricant. Other commercial
chain lubricants may contain solvent
which could damage the O-rings.
Drive Chain Adjustment
Adjust the drive chain before every
ride.
NOTE: Always adjust drive chain with
the driver, or equivalent weight, seated
on the vehicle.
1. Select a level surface and set trans-
mission to NEUTRAL.
Loosen rear axle lock bolts.
vmo2008-011-052_a
1. Rear axle lock bolts
2. Insert screw driver pin (tool kit)
through sprocket hub and into ec-
centric axle housing.