Can-Am DS 450 X mx Operator's Manual page 102

MAINTENANCE PROCEDURES
vmo2008-011-085_a
1. Screwdriver
2. Clutch adjustment wrench
By using the screwdriver, gently turn
clutch adjuster screw clockwise to lo-
cate the point of contact with release
bearing, then turn screw out (counter-
clockwise) 3/8 to 1/2 turn from contact
point.
Hold adjustment screw using the flat
screwdriver, then tighten lock nut
clockwise using the clutch adjustment
wrench.
vmo2008-011-085_b
1. Screwdriver
2. Clutch adjustment wrench
To confirm proper adjustment, gen-
tly push on adjustment screw using a
screwdriver. A small axial play of ap-
proximately 0.5 mm (.02 in) should be
felt. If not, perform adjustment again.
______________
100
vmo2010-012-003_a
1. Adjustment screw
A. 0.5 mm (.02 in)
NOTICE
A premature clutch disk
wear may occur if adjustment is too
tight.
Reinstall access plugs.
NOTICE
Do not overtighten.
vmo2010-012-001_a
1. Access plugs
2. Clutch cover
Properly adjust clutch lever. Refer to
ADJUSTMENT AT CLUTCH LEVER
above.