Drive Chain And Sprockets - Can-Am DS 250 Operator's Manual

MAINTENANCE PROCEDURES
Tighten bolts when proper adjustment
is obtained.
Taillight Bulb Replacement
Ensure the ignition switch is in the OFF
position.
Unscrew lens screws and remove lens
to expose bulb.
V06G0UY
1. Lens
2. Screws
Push bulb in and hold as you turn it
counterclockwise to release it from
the socket.
Install the new bulb by first pushing
and holding it in as you turn it clock-
wise to lock it in the socket.
Check light operation after bulb re-
placement.
Reinstall lens.

Drive Chain and Sprockets

NOTICE
Check drive chain for
proper adjustment and lubrication
before each use.
______________
114
2
1
CAUTION Ensure the engine
is OFF and the parking brake is en-
gaged before checking, adjusting or
lubricating the drive chain.
NOTICE
Never operate this vehi-
cle with the drive chain too loose or
too tight as severe damage to the
drive components can occur.
Drive Chain and Sprocket
Inspection
This vehicle is equipped with O-ring
sealed, permanently greased, pins and
rollers. Before operating the vehicle,
always inspect the drive chain.
Check the free play of the drive chain
and adjust if necessary.
Check for damaged or missing O-rings
or and rollers.
Check the sprocket axle and pinion
for distortion, excessive wear or other
damage.
V02H02Y
1. Good
2. Replace
NOTICE
Replace the chain and
sprockets together to prevent rapid
chain and sprocket wear. Install a
new retaining ring each time the en-
gine sprocket is removed.
1
2