Indicator Lamps - Can-Am DS 450 EFI X mx Operator's Manual

CONTROLS/INSTRUMENT/EQUIPMENTS
3. Press selector button and HOLD
for 2 seconds. This will change the
displayed mode to either Speed,
RPM or Combined.
4. To select another mode, repeat
steps 2 and 3 until you get the
mode desired.
Multifunction Display
(Temporary Display Mode)
Press and release selector button to
change the normal display mode to the
following temporary mode:
– Odometer
– Trip meter (resettable)
– Hour meter (resettable)
– Vehicle hour meter.
vmr2007-050-002_n
1. Selector button
The gauge will display the selected
mode for 10 seconds then will return
to the normal display mode.
While in a resettable mode, push and
HOLD selector button for 2 seconds to
reset it.
Odometer (ODO)
Odometer records the total distance
travelled either in miles or kilometers.
Trip Meter (trip)
The trip meter records distance trav-
elled since it has been reset. Distance
travelled is displayed either in miles or
kilometers.
______________
62
It can be used to establish a fuel tank
range or distance between 2 way
points for instance.
Push and HOLD display selection but-
ton for 2 seconds to reset the trip me-
ter.
Hour Meter (trip time)
The hour meter records vehicle run-
ning time when the electrical system
is activated. It can be used to establish
traveling time between 2 way points
for instance.
Push and HOLD display selection but-
ton for 2 seconds to reset the hour me-
ter.
Hour Meter (engine hours)
The hour meter records engine running
time.
Multifunction Display Messages
TROUBLESHOOTING
Refer to
tion.

Indicator Lamps

vmr2007-050-002_o
1. Check engine indicator lamp
2. High beam indicator lamp
3. Flasher/hazard signal indicator lamp
4. MPH or km/h indicator lamp
sec-