Can-Am DS 450 EFI X mx Operator's Manual page 105

NOTE: Make sure that clutch cable
is loose and clutch release cam is fully
released before performing this adjust-
ment.
vmo2009-010-104_a
CLUTCH RELEASE CAM - FULLY RELEASED
1. Clutch release cam
2. Clutch cable
A. 4 to 5 mm
4. Install the
wrench (P/N 529 036 076) provided
in tool kit onto lock nut.
529035081
vmo2008-011-071_a
1. Lock nut
clutch adjustment
______________
MAINTENANCE PROCEDURES
5. Hold adjustment screw using a flat
screwdriver, then loosen lock nut
counterclockwise.
vmo2008-011-085_a
1. Screwdriver
2. Clutch adjustment wrench
6. By using the screwdriver, gently
turn clutch adjuster screw clock-
wise to locate the point of con-
tact with release bearing, then turn
screw out (counterclockwise) 1/2
turn from contact point
7. Hold adjustment screw using the
flat screwdriver, then tighten lock
nut clockwise using the clutch ad-
justment wrench.
vmo2008-011-085_b
1. Screwdriver
2. Clutch adjustment wrench
103