Engine Coolant - Can-Am DS 450 EFI X mx Operator's Manual

2. Remove the oil filter and discard
O-ring.
vmo2008-011-084_a
LH SIDE OF ENGINE
1. Oil filter cover
2. Oil filter
3. O-ring
3. Install the new oil filter with a NEW
O-ring.
NOTE: Apply oil on the filter and O-ring
before installation.
4. Wipe off any oil spillage on engine.
5. Refill oil tank with 1.8 L of the rec-
ommended oil. Refer to
MENDED ENGINE OIL
tion for more details.
6. Start engine and let idle for a few
minutes. Ensure there are no
leaks.
7. Stop engine and check oil level. Re-
fill if necessary.
Dispose of used oil and filter as per
your local environmental regulations.

Engine Coolant

Engine Coolant Level
WARNING
Check coolant level with engine
cold. Never add coolant in cooling
system when engine is hot.
NOTE: While checking the coolant
level, visually inspect engine area for
leaks.
The engine coolant tank cap is locat-
ed underneath access cover near fuel
tank cap.
vmo2008-011-061_a
UNDERNEATH ACCESS COVER
1. Coolant tank cap location
RECOM-
in this sec-
vmo2008-011-034
COOLANT TANK CAP
To remove access cover, proceed as
follows:
1. Remove seat.
_______________
MAINTENANCE PROCEDURES
93