Table of Contents
Advertisement
Communications Menu
Press the Menu button to open the OSD menu. Press the arrow keys (pq) to select SETUP and press
the Enter button to enter the SETUP menu. Press the arrow keys (pq) to select Communications and
press the Enter button to enter the Communications menu. Press the arrow keys (pq) to select the
menu option and press the Enter button to enter its submenu. Press the arrow keys (pqtu) to select or
adjust the desired settings and press the Enter button to confirm.
I
tem
LAN
WLAN
Control
Network Reset
Serial Port Baud Rate
PICTURE
LAN
WLAN
OUTPUT
Control
Network Reset
Serial Port Baud Rate
SETUP
Projector Address
IR Control
OPTION
Configure the local area network (LAN) settings.
•
DHCP: Turn the DHCP ON/OFF.
•
IP Address: Assign Network IP Address.
•
Subnet Mask: Assign Network Subnet Mask.
•
Default Gateway: Assign Network Default Gateway.
•
DNS: Assign DNS.
•
MAC Address: Display the network MAC Address value.
•
Apply: Apply Network settings.
Configure the wireless local area network (WLAN) settings.
•
Enable: Enable/Disable WLAN.
•
Start IP: Start of IP Address.
•
End IP: End of IP Address.
•
IP Address: Assign Network IP Address.
•
Subnet Mask: Assign Network Subnet Mask.
•
SSID: Assign Network Service Set Identifier.
•
Apply: Apply Network settings.
Configure network control settings.
•
Crestron: Use this function to select the network function (port: 41794).
•
PJ Link: Use this function to select the network function (port: 4352).
•
AMX Device Discovery: Use this function to select the network function
(port: 9131).
•
Telnet: Use this function to select the network function (port: 3023).
•
HTTP: Use this function to select the network function (port: 80).
Reset network setting to the factory defaults.
Select the serial port its baud rate. Available options: 1200, 2400, 4800,
9600, 14400, 19200, 38400, 57600, and 115200.
DLP Projector — Owner's Manual
Communications
D
escrIptIon
41
—
—
115200
0
Advertisement
Table of Contents
