Table of Contents
Advertisement
Communications Menu
Press the Menu button to open the OSD menu. Press the arrow keys (pq) to select SETUp and press
the Enter button to enter the SETUp menu. Press the arrow keys (pq) to select Communications and
press the Enter button to enter the Communications menu. Press the arrow keys (pq) to select the
menu option and press the Enter button to enter its submenu. Press the arrow keys (pqtu) to select or
adjust the desired settings and press the Enter button to confirm.
I
tem
LAN
WLAN
Network
Serial Port Baud Rate
Projector ID
pICTURE
LAN
WLAN
Network
OUTpUT
Serial Port Baud Rate
Projector ID
SETUp
OpTIOn
Configure the local area network (LAN) settings.
•
DHCP: Turn the DHCP ON/OFF.
•
IP Address: Assign Network IP Address.
•
Subnet Mask: Assign Network Subnet Mask.
•
Default Gateway: Assign Network Default Gateway.
•
MAC Address: Display the network MAC Address value.
•
Apply: Apply Network settings.
Configure the wireless local area network (WLAN) settings.
•
Enable: Enable/Disable WLAN.
•
Start IP: Start of IP Address.
•
End IP: End of IP Address.
•
Subnet Mask: Assign Network Subnet Mask.
•
Default Gateway: Assign Network Default Gateway.
•
MAC Address: Display network MAC Address value.
•
SSID: Assign Network Service Set Identifier.
Configure the general network settings.
•
Projector Name: Display the projector hostname for Network.
•
Restart Network: Restart the network.
•
Network Factory Reset: Perform factory reset on the network settings.
The Projector Name, LAN IP, WLAN IP, and SNMP settings will be reset.
Select the serial port and baud rate.
Set the projector ID number. The projector will respond to IR remotes set
either at the same address as the projector or to IR remotes set to address
0.
DLP Projector — Owner's Manual
Communications
D
escrIptIon
41
—
—
19200
0
Advertisement
Table of Contents
