Epson Stylus Pro 7900 User Manual page 97

Epson Stylus Pro 7900/7910/9900/9910
Error messages
SProofer DISCONNECTED
SpectroProofer IS
DISCONNECTED
DO YOU CONTINUE?
NO
YES
DEVICE ALIGNMENT
ADJUSTMENT NOT COMPLETE
ILS20EP DISCONNECTED
ILS20EP IS DISCONNECTED
DO YOU CONTINUE?
NO
YES
Service call / Maintenance call
Error messages
MAINTENANCE REQUEST
NNNN
CALL FOR SERVICE
NNNN
CONTACT THE
REPAIR CENTER
User's Guide
Problem Solver
Description
The SpectroProofer is not
connected to the printer
properly.
The initial settings have
not been made for the
SpectroProofer.
The color measurement
device (ILS20EP) is not
connected properly.
Description
A part used in the
printer has nearly
reached the end of its
life.
If 3000 appears, the
power cord is not
plugged into the
electrical outlet or the
AC inlet of the printer
properly
A fatal error has
occurred.
97
What to do
Select NO, and then turn the printer off, and
then connect the SpectroProofer to the printer
properly. If you select YES, the printer continues
printing.
See the SpectroProofer Mounter 24"/44"
Setup Guide
Refer to the following guide to make initial
settings to the SpectroProofer.
See the SpectroProofer Mounter 24"/44"
User's Guide
Select NO, and then turn the printer off, and
then connect the color measurement device
(ILS20EP) properly. If you select YES, the printer
continues printing.
See the SpectroProofer Mounter 24"/44"
Setup Guide
What to do
Note the code and contact your dealer.
See "When the maintenance call error
occurs" on page 98
Turn the printer off. Plug the power cord into
the electrical outlet or the AC inlet of the
printer properly. Then, turn the printer on and
off a few times. If this message appears on the
LCD panel again, contact your dealer.
See "When the service call error occurs"
on page 98
Turn the printer off, leave it for a while, and
turn the printer on again. If this message
appears on the LCD panel again, note the
code and contact your dealer.
See "When the service call error occurs"
on page 98