Epson Stylus Pro 7900 User Manual page 48

Epson Stylus Pro 7900/7910/9900/9910
G
Tape the leading edge of the roll paper to
the take-up reel core in three places.
H
Press the button to feed the paper
forward and create a loop of slack.
I
Set the Manual switch to Forward and hold
it for a while to take up the roll paper for
three or more revolutions of the take-up
paper core.
After taking up the paper, ensure that there
is adequate slack between the roll paper
and the take-up reel core.
Note:
For Singleweight Matte Paper with a 24-inch
width or wider, place the Tensioner in the
slack of the roll paper. Make sure to place it in
the center of the roll paper.
User's Guide
Paper Handling
Winding paper backward
A
Turn on the printer, and then pull out the
roll paper. See step 3 to 6 of the following
section.
"Winding paper forward" on page 47
B
Pull the bottom of the roll paper around the
back of the reel core as shown below. Then
tape the leading edge of the paper to the
reel core in three places.
C
Press the
forward and create a loop of slack.
D
Set the Manual switch to Backward and
hold it for a while to take up the roll paper
for three or more revolutions of the take-up
paper core.
After taking up the paper, ensure that there
is adequate slack between the roll paper
and the take-up reel core.
48
button to feed the paper