Epson Stylus Pro 7900 User Manual page 49

Epson Stylus Pro 7900/7910/9900/9910
Taking up your prints
When the Auto Take-up Reel Unit is installed,
and the take-up reel core is loaded with paper to
take up in the desired direction, you can use the
unit to take up your prints.
Warning:
w
Do not touch the Auto Take-up Reel Unit while
it is operating. Doing so may result in injury.
A
Set the Auto switch to Forward or
Backward.
B
Send a print job to the printer.
The printer starts printing. The Auto
Take-up Reel Unit takes up the roll paper in
the direction you set in step 1.
Note:
When printing by using the Roll Auto Cut On
set the Auto switch of the Auto Take-Up Reel Unit to
Off, otherwise the printer does not cut the paper. You
can set the Auto switch to Off during printing to cut
the paper automatically.
User's Guide
Paper Handling
Removing paper after take-up
After paper take-up, follow the steps below to
remove the take-up reel core.
A
Set the Auto switch to Off.
B
Cut the roll paper.
❏ Press the
paper.
❏ If the roll paper cannot be cut with the
built-in cutter, use a scissors or cutter
sold at a store.
C
Turn the lever to unlock the movable unit,
and then slide it to the left so that the flange
knob clears the end of the take-up reel core.
While doing this, support the take-up reel
core with one hand to keep it from falling.
,
49
button to cut the roll