Epson Stylus Pro 7900 User Manual page 26

Epson Stylus Pro 7900/7910/9900/9910
CUSTOM PAPER
When you use non-Epson media, you need to make settings suitable for the media.
After you have selected the paper number, make the following settings. Make sure to select the paper
from PAPER TYPE first, and then make the PLATEN GAP setting and so on.
To set the custom paper, see the following section.
"Setting the custom paper in the printer" on page 157
Item
PAPER TYPE
PLATEN GAP
THICKNESS PATTERN
PAPER FEED ADJUST
DRYING TIME
PAPER SUCTION
SET ROLL PAPER
TENSION
REMOVE SKEW
User's Guide
The Control Panel
Parameter
Photo Paper
Proofing Paper
Fine Art Paper
Matte Paper
Plain Paper
Others
NARROW
STANDARD
WIDE
WIDER
PRINT
0.00%
-0.70% to +0.70%
0.0sec
0.0sec to 10.0sec
STANDARD
-1 to -4
STANDARD
HIGH
HIGHER
ON
OFF
Explanation
You can select the media type that is most similar to the
paper you are using.
You can adjust the distance between the print head
and paper.
STANDARD: Normally, select STANDARD.
NARROW: Use this when printing on thin paper.
WIDE or WIDER: Select this if you find that printed images
are smeared.
You can print the paper thickness detection pattern.
You can set the paper feed amount of the printable
area. The range is -0.70 to 0.70%. If the paper feed value
is too large, white horizontal micro-banding may
appear. If the paper feed value is too small, dark
horizontal micro-banding may appear.
You can set the ink drying time for each print head
pass. The range is 0 to 10 seconds. Depending on the
ink density or paper type, the ink does not dry soon. In
this case, set the drying time longer.
You can set the suction pressure used to feed the
printed paper.
When using a cloth or thin paper or when wrinkles
appear in the paper during printing, select HIGH or
HIGHER.
You can select whether to perform this operation to
reduce the paper skew or not.
26