Multicast Paging - Yealink SIP-T29G User Manual

User Guide for the SIP-T29G IP Phone
To place an intercom call when the target phone is idle:
1. Press the intercom key when the phone is idle.
The called destination plays a warning tone and automatically answers the call in
the speakerphone mode by default.
2. To end the intercom call, press the intercom key again or the EndCall soft key.
You can use multicast paging to quickly and easily broadcast time sensitive
announcements to people who are listening to a specific multicast group. You can
configure a multicast paging key or paging list key on the phone, which allows you to
send a Real Time Transport Protocol (RTP) stream to the pre-configured multicast
address(es) without involving SIP signaling. You can configure the phone to receive an
RTP stream from pre-configured multicast listening address(es) without involving SIP
signaling. You can specify up to 10 multicast listening addresses.
To configure a multicast paging key via phone user interface:
1. Press Menu->Features->DSS Keys.
2. Select the desired DSS key.
3. Press
4. Press
Type field.
5. (Optional.) Enter the string that will appear on the LCD screen in the Label field.
6. Enter the multicast IP address and port number (e.g., 224.5.6.20:10008) in the Value
field.
The valid multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
140
or , or the Switch soft key to select Key Event from the Type field.
or , or the Switch soft key to select Multicast Paging from the Key