Yealink SIP-T29G User Manual page 32

User Guide for the SIP-T29G IP Phone
Secondary DNS fields respectively.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
If you are using an xDSL modem for IPv4 network connection, you can connect your
phone to the Internet via PPPoE mode. Set the WAN port as a PPPoE port. The PPPoE port
will perform a PPP negotiation to obtain the IP address. Contact your system
administrator for the PPPoE user name and password.
To configure PPPoE via phone user interface:
1. Press Menu->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Press
3. Enter the user name and password in the corresponding fields.
4. Press the Save soft key to accept the change or the Back soft key to cancel.
Note
Wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters,
contact your system administrator.
Generally, your phone will be deployed with multiple other phones. In this case, your
system administrator will configure the phone parameters beforehand, so that after you
start up your phone, the phone will be registered and ready for use. The SIP-T29G IP
phone supports up to 16 accounts. If your phone is not registered, you may have to
22
or , or the Switch soft key to select the PPPoE from the Type field.