Call Waiting - Yealink SIP-T29G User Manual

User Guide for the SIP-T29G IP Phone
advance. Refer to
Press the Directory soft key, and then select Remote Phone Book. Select the
-
desired group and search for the contact (Directory should be configured in
advance. Refer to
for more information).
3. Press
4. After the party answers the call, press
transfer.
If you are using a handset, the transfer can be completed by hanging up the handset.
You can cancel the transfer before the call is connected by pressing the Cancel soft key.
You can enable or disable call waiting on the phone. If call waiting is enabled, you can
receive another call while there is already an active call on the phone. Otherwise,
another incoming call is automatically rejected by the phone with a busy message
when there is an active call on the phone. You can also enable or disable the phone to
play a warning tone when receiving another call.
To configure call waiting via phone user interface:
1. Press Menu->Features->Call Waiting.
2. Press
field.
3. Press
4. (Optional.) Enter the call waiting on code or off code respectively in the On Code or
Off Code field.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Call waiting is configurable via web user interface at the path Features->General
Information.
118
Directory
Directory
or to dial out.
or , or the Switch soft key to select Enabled from the Call Waiting
or , or the Switch soft key to select Enabled from the Play Tone field.
on page 39 for more information).
on page 39 and Remote Phone Book
or the Transfer soft key to complete the
on page 56