Table of Contents
Advertisement
Replacing the Transfer Roll
This section describes procedures for replacing the transfer roll.
CAUTION
• Never throw a used transfer roll into a fire. It could explode resulting in burns and
injuries.
• Do not touch the edge of the plate at the upper side of the transfer roll because it is
sharp.
1.
Remove any print jobs from the face down tray, close the bypass tray cover before
opening the front door.
2.
Push up the button A and fully open the
front door.
3.
Grip the tabs at both ends of the transfer
roll and gently lift it out of the printer.
Important
• Do not touch inside the printer with your hands. Some
parts may be hot.
4.
Unpack a new transfer roll and grip the tabs
as shown in the diagram.
5.
Align the arrow marks on the transfer roll to
the marks on the printer, and gently push
the roller into the printer.
6.1 Replacing Consumables
93
Advertisement
Table of Contents
