Procedure - Fujitsu DL3700 Pro User Manual

USING SETUP MODE
<<FUNCTION>>
SAVE&END MENU1
V-ALMNT
5 - 4 4
#05 Chapter 5
Any settings changed while in setup mode are saved as the new
power-on defaults for the printer. The new defaults remain active
until you change them again.
NOTE
The only way to exit setup mode without saving your changes is to
turn off the printer. When you turn the printer back on, the
previous default settings are used.

Procedure

To exit setup mode and save your changes using SAVE/END,
proceed as follows:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on
the page. If the menu is not printed, press the ONLINE
button to print the menu. If you are using the SELF-TST or
HEX-DUMP function, press the LOCK button instead of the
ONLINE button to print the menu. The <<FUNCTION>>
menu is shown below.
MENU2 HARDWRE ADJUST
2. Select the SAVE/END function.
Make sure that the red cursor is positioned under SAVE &
END. Press the FONT button or the MENU button to select
SAVE & END. The printer exits setup mode and returns
online (the ONLINE indicator lights green). Any changes you
made while in setup mode are saved.
44
CONFIG DEFAULT LIST SELF-TST
11.08.1998, 23:03 Uhr
HEX-DUMP
User's Manual