USING SETUP MODE
5 - 2 4
#05 Chapter 5
Table 5.3 MENU1 and MENU2 Items and Options (Cont.)
NOTES:
• Underlined options are the factory defaults.
• Asterisks identify items and options that differ for the IBM XL24E and
Epson ESC/P2 emulations. The notes are defined at the end of the table.
MENU1 and
MENU2 Items
<CHR-SET>
SET 1
SET 2
(*4)
ITALIC
GRAPHIC
<AGM> (*2)
OFF
ON
<PRF-SKP>
SKIP
NO-SKIP
24
Options
Description
IBM character set 1
IBM character set 2
If a downloaded (soft) font is used,
the character set for that font
overrides the <CHR-SET> setting.
Italic characters are available.
Graphics characters (ruled lines) are
available.
Specifies that Alternate Graphics
Mode (AGM) is off. The base of line
spacing is 1/72 inch or 1/216 inch.
Specifies that Alternate Graphics
Mode (AGM) is on. The base of line
spacing is 1/60 inch or 1/180 inch.
For continuous forms, this option
specifies whether an inch is skipped
around the perforation. If you are
not using software to specify a
bottom margin, select SKIP when
using thicker, multipart forms.
One inch is skipped around the
perforation.
The perforation is not skipped.
Printing continues in the bottom
margin of the page.
11.08.1998, 23:03 Uhr
User's Manual