Fujitsu DL3700 Pro User Manual page 101

User's Manual
#05 Chapter 5
Function
HARDWRE FORMAT
ADJUST
CONFIG
13
Table 5.2 Required Options (Cont.)
Item
If you have a serial interface, the serial
BAUD-RT interface options selected on the printer
PROTOCL must be the same as the settings you
DSR selected using your software or your
DUPLEX computer operating system. If the settings
are not the same, the printer will not
print or will print garbage.
See the section Changing Hardware
Options later in this chapter.
None If you are not using software to specify
the top margin of the page, use the
printer's default top-of-form setting,
1 inch (25.4 mm) from the top of the
paper. If you are using software to
specify the top margin of the page,
change the default setting to 1/6 inch
(4.2 mm).
See the section Changing Print Position
Adjustment Options later in this
chapter.
None If you are using paper that is dark-
colored or preprinted with dark colors,
you may need to disable the AREA
OVER detection function.
See the section Changing Configuration
Options later in this chapter.
11.08.1998, 23:03 Uhr
USING SETUP MODE
Option
5 - 1 3