Changing Configuration Options - Fujitsu DL3700 Pro User Manual

USING SETUP MODE
CHANGING
CONFIGURATION OPTIONS
5 - 3 8
#05 Chapter 5
5. Exit setup mode, saving the top-of-form setting.
Make sure that the red cursor is positioned beneath SAVE &
END, then press the FONT button or the MENU button.
6. Check the top-of-form setting.
Load your paper and check the adjustment by printing a
sample page using your software. If necessary, reenter setup
mode and fine-tune the top-of-form position by changing the
<CNTFINE> option.
The CONFIG function defines the printer's primary configuration.
You can set the following options to ensure that the printer meets
your requirements:
• Tear off for continuous forms
• Autoloading of single sheets
• Direct decoding of certain commands
• Enabling of the AREA OVER indicator
Table 5.6 describes the CONFIG items and options. Items are listed in
the order they are printed. The procedure for changing the
configuration options is described after Table 5.6.
Table 5.6 CONFIG Items and Options
NOTE: Underlined options are the factory defaults.
CONFIG Items
<TEAROFF>
38
Options Description
Auto or manual tearoff feed.
MANUAL Automatic tearoff feed is invalid,
and tearoff feed must be done using
the TEAR OFF button.
AUTO Automatic tearoff feed is valid but
only for continuous forms. Tearoff
feed can also be done using the TEAR
OFF button.
11.08.1998, 23:03 Uhr
User's Manual