Resuming From An Area Over - Fujitsu DL3700 Pro User Manual

PRINTING
4 - 8
#04 Chapter 4
CAUTION
When using the cut sheet stand or when printing remaining lines, be
careful not to print on the platen. Printing on the platen may damage
both the platen and the print head.
Continuing printing after supplying paper
1. Install paper on the forms tractors, on the cut sheet stand, or in
the cut sheet feeder bin, as described in Chapter 3.
2. To load the first sheet of paper, press the LOAD button. The
PAPER OUT indicator will turn off.
3. Press the ONLINE button to place the printer online. The
printer resumes printing.
NOTE
For continuous forms paper, the page where printing
stopped and the page where printing resumes may be
incorrectly printed. In this case, wait for the entire job to
finish printing. Then reprint the incorrect pages.

Resuming from an Area Over

The printer senses the left and right edges of paper and stores their
positions when the paper is loaded. If your software will print data
past either edge, the printer ignores that data but does not stop
printing. Rather, the AREA OVER indicator lights to call your
attention to the loss of data.
The AREA OVER indicator functions when AREACNT (area control)
is set to ENABLE in setup mode. See Chapter 5 for information on
setting AREACNT. The factory default is not to sense the edges. If
paper is dark-colored or preprinted, the printer may not be able to
sense the edges correctly. In this case, disable the sensor.
8
User's Manual
11.08.1998, 23:02 Uhr