Fujitsu DL3700 Pro User Manual page 66

PAPER HANDLING
3 - 1 6
#03 Chapter 3
6. Fit the paper feed holes onto the left and right tractor pins.
Adjust the left tractor (as seen from the rear of the printer) to the
width of the form. Close the paper holders.
Paper holders
7. Pull the left tractor (as seen from the rear) to stretch the paper
taut. Push the left locking lever down to secure the tractor in
place.
8. Reinstall the cut sheet stand. For installation, see the section
Installing the Cut Sheet Stand in Chapter 2.
9. When using paper-stapled multipart forms, raise the cut sheet
stand to the up position. For other continuous forms paper,
lower the cut sheet stand to the down position.
Cut sheet
stand
16
Adjusting paper tension
Lowering the cut sheet stand
21.08.1998, 23:48 Uhr
User's Manual