Installing The Ribbon Cartridge - Fujitsu DL3700 Pro User Manual

User's Manual
#02 Chapter 2
3. Hold the cut sheet stand at an angle over the top of the printer.
Slide the mounting pins into the long, front grooves of the
notches. This is the cut sheet stand's up position, used for
printing single sheets.
To rotate the cut sheet stand to its down position, grasp it at the
sides and lift it up until the two upper mounting pins fall into
the rear grooves of the notches. This position is used for
printing most continuous forms.

Installing the Ribbon Cartridge

The basic printer uses a black ribbon cartridge. If you have a color kit
option, you can use either color or black ribbon cartridges. To install
the ribbon cartridge:
1. Open the front cover of the printer. For easy installation, slide
the print head carriage so that it does not face a bail roller.
2. The paper thickness lever, located on the right of the printer,
has nine positions. Before you install the ribbon cartridge,
move this lever to D.
7
Paper thickness lever
Move to D.
Preparing to install the ribbon
21.08.1998, 23:47 Uhr
SETTING UP
2 - 7