CONNECTING THE POWER
CORD
User's Manual
#02 Chapter 2
Looking at the printer from the back with the cut sheet stand and back
cover removed, you can see the following parts of the printer:
Cut sheet stand
Back cover
Forms tractors
Before you plug in the printer:
√ Make sure that the printer power is switched off. The side
marked "1" on the power switch should be raised.
√ Make sure that the power outlet is properly grounded.
√ Make sure that you use the power cord shipped with the
printer. This cord is designed to minimize radio frequency
interference.
11
Top cover
Power
connector
Printer components (rear)
21.08.1998, 23:47 Uhr
SETTING UP
Acoustic cover
Rating label
2 - 1 1