Online Setup Mode - Fujitsu DL3700 Pro User Manual

USING SETUP MODE

ONLINE SETUP MODE

5 - 5 8
#05 Chapter 5
The preceding sections describe offline setup mode. This section
introduces online setup mode. The tedious task of setting up printer
features one-by-one from the control panel and printing and checking the
desired options on paper can be avoided by using online setup mode. In
online setup mode, printer features are set via the computer rather than
the printer control panel.
Put the printer in online setup mode, in either of the following two ways:
• Turn the printer off and then turn the printer back on while
pressing the MENU button. Hold down the button until the
printer beeps.
• Issue the printer command ESC e ONLINE. This command is
valid in any emulation.
Send setup data from the computer in any of the following three ways:
• Enter setup data directly from the computer keyboard before
starting your job. With MS-DOS, hold down the Ctrl key and
type P. Data entered from the keyboard is sent directly to the
printer. When data entry is complete, hold down the Ctrl key
again and type P. This method is useful when just a few
settings need to be changed.
• Use an editor program to prepare a setup data file and then
send the file to the printer using a command before starting
your job. With MS-DOS, use the COPY command. This
method is useful when settings are used repeatedly.
• Write a program that enables interactive entry of setup data on
the CRT screen. This method is the most useful of the three.
Check with your dealer for currently available programs.
To exit from online setup mode, send EXIT as the last setup data.
For details of setup data and its format, refer to the programmer's manual
for each emulation.
58
User's Manual
11.08.1998, 23:03 Uhr