Holding Calls; Transferring A Call; Conference - iPECS LIP-9070 User Manual

LIP-9070
3.3

Holding Calls

You can place a call in a waiting state where the caller is connected to the Music on Hold source of the iPECS
system, freeing you for other activities. The call will remain on hold for the hold recall time then the user is recalled.
To place a call on Hold, touch the Hold/Save button, the button will light to indicate the held call.
3.4

Transferring a Call

Once connected to a call the Transfer icon, as
highlighted on the right, is used to send the call to
another destination. After touching the Transfer icon,
dial the station to receive the call. The call transfer
can be unannounced (simply hang-up) or announced
(after the receiving party answers, announce the call
and hang-up).
Note
°
A transfer can be accomplished by touching
a Flex button assigned as a DSS for another
station in the iPECS host.
3.5

Conference

An active call can be joined with another call to
establish a conference. If the iPECS host is equipped
with a Conference bridge, up to 32 parties can be
included in a conference.
To conference calls,
1. Place/receive first call as usual.
2. Touch the CONF soft button,
3. Place next call and press the CONF soft
button.
4. Repeat step 3 for additional parties
5. Press the CONF soft button again to connect
all parties.
Note
°
The LIP-9070 supports a 3-party conference without the need of a Conference bridge. If conferences with
more than three parties are required, the iPECS host must be equipped with a conferencing bridge such as
the MCIM.
9
iPKTS
User Guide