Removing The Cord Cover; Mounting The Phone And Pedestal; Network Connections - iPECS LIP-9070 User Manual

LIP-9070
2.2

Removing the Cord Cover

Before proceeding with the installation, the Line Cord
Cover, which protects the LAN cabling, should be
removed from the pedestal. To remove the cover, lift
the cover plate as shown.
2.3

Mounting the Phone and Pedestal

The phone attaches to the pedestal in either a 40° or 60° angle
and should be adjusted at installation for the preferred viewing
angle. To mount the phone on the pedestal,
1. Remove the wiring cover as in section 2.2.
2. Select which side of the pedestal to use, 40° or 60°, and
align the grooves in the base of the phone with the
appropriate hooks on the pedestal.
3. Pull down at the top of the phone to engage the hooks
of the pedestal with the slots in the phone base.
2.4

Network Connections

The LIP-9070 has two RJ-45 Ethernet LAN
jacks on the bottom of the phone. One of the
jacks is the interface to a local IEEE
10/100/1000 Base-T Network port. The other
jack is a 10/100/1000 Base-T port for
connection to a PC.
The network interface port jack is wired as a
standard MDI connection and the PC port is
wired as an MDIX connection.
structure allows use of straight-through cables.
The LIP-9070 network and PC ports support
Auto negotiation for MDI/MDIX, speed and
duplex (full or half).
wiring for the LIP-9070 network and PC
connections are in accordance with TIA/EIA
standard 568.
This wiring
The MDI and MDIX
3
iPKTS
User Guide