Table of Contents
Advertisement
Making VoIP settings
Using the connection assistant
Automatic firmware update
Your phone will check daily whether a newer firmware update is available via the Internet
on the Gigaset configuration server. If this is the case, the message
will be displayed when the handset is in idle status, and the message key f flashes.
f
Press the message key.
Press the display key to confirm the prompt.
§Yes§
The firmware will be loaded onto your phone.
Please note:
– If you reply to the request with §No§, the display will not be repeated. The message
will only be shown again if a newer version of the firmware than the one rejected is avail-
available
able.
– You can deactivate the automatic version check via the Web configurator (page 150).
Making VoIP settings
In order to be able to use VoIP, you must set a few parameters for your phone.
You can make the following settings using your handset.
u
Download the general access data for your VoIP provider from the Gigaset configuration
server and store them on your phone.
u
Enter your personal access data for your first VoIP account (first VoIP phone number).
You can configure the access data for five further VoIP accounts via the phone's Web
configurator.
u
Set the phone's IP address in the LAN.
Please note:
You can set these and other parameters conveniently via the Web configurator on a PC connected to
your local network (see page 113).
The connection assistant on your phone can help you make the settings.
Using the connection assistant
The connection assistant starts automatically when you set the handset and base station
up for the first time, or when you try to connect to the Internet before making the neces-
sary settings.
You can also start the connection assistant via the menu:
¢
¢
v
Ð
Settings
Connection Assist.
Select and press
~
Enter the system PIN and press
For how to enter VoIP settings using the connection assistant, see page 19.
106
Telephony
.
§OK§
.
§OK§
New firmware available
New firmware
Advertisement
Table of Contents
