Table of Contents
Advertisement
When making calls from the fixed line network, the caller's phone number is not displayed
although CLIP (page 34) is set.
Calling Line Identification is not enabled.
¥
The caller should ask his network provider to enable Calling Line Identification (CLI).
You hear an error tone when keying an input (a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user guide if necessary.
You cannot connect to the router and the phone is assigned a static IP address.
¥
Check on the router whether the IP address is already being used by another device in the LAN or
belongs to the block of IP addresses that is reserved on the router for dynamic address assignment.
¥
If necessary, change the phone's IP address (page 108).
You have made a call via VoIP but cannot hear the other caller.
Your phone is connected to a router with NAT/firewall.
¥
Your STUN server (page 128) or outbound proxy (page 129) settings are incomplete or incorrect.
Check the settings.
¥
No outbound proxy is entered or the outbound proxy mode
phone is connected to a router with symmetric NAT or a blocking firewall.
¥
Port forwarding is activated on your router, but no permanent IP address has been assigned to
your phone.
You cannot make calls via VoIP.
¥
First wait a few minutes. This is often a short-term event that corrects itself after a short time.
If the message is still displayed, proceed as follows:
¥
Check whether your phone's Ethernet cable is correctly connected to the router.
¥
Check your router's cable connection to the Internet.
¥
Check whether the phone is connected to the LAN. Send a ping command, e.g. from your PC, to
the phone (ping s <local IP address of the phone>). It may be that no IP address could be assigned
to the phone or a permanently set IP address is already assigned to another LAN subscriber. Check
the settings on the router, you may have to activate the DHCP server.
You cannot make calls via VoIP. Either
¥
First wait a few minutes. This is often a short-term event that corrects itself after a short time.
The message may still be displayed for the following reasons:
1. The personal VoIP access data (Username,
may be incomplete or wrong.
¥
Check your information. In particular, check your use of upper and lower case.
2. The general settings for your VoIP provider are incomplete or incorrect (incorrect server address).
¥
Start the Web configurator and check the settings.
You cannot make calls via VoIP. The display shows
(xxx = VoIP status code).
You are trying to make a call via a VoIP connection that is not properly configured.
¥
Start the Web configurator and check the settings. Possible status codes and their meanings are
listed on page 157.
The phone does not dial an entered number. The display shows
The number may be blocked (dial rule).
¥
Open the
Dialling Plans
Server not accessible!
Provider registration failed!
Authent. Name
Web page of the Web configurator and delete or deactivate the block.
Never
is activated (page 129) and your
is displayed.
or
Registration failed
and
Authent.
Password) you have entered
IP configuration error: xxx
Not
possible!.
Appendix
Questions and answers
is shown.
or
VoIP config.error: xxx
155
Advertisement
Table of Contents
